Nearly all of the time, companies will spend lots of money to purchase their lift trucks. It is essential, therefore to take good care of your machinery to protect your investment into the long run. It is a great idea to know the procedures which are undertaken during taking care of and maintaining this machinery.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is working. Like for instance, if there are any knocks or misses, the equipment is defective and this should raise several concerns. Furthermore listen carefully for any squealing noise that come from the belts as these noises would provide you with a lot of information.
Some of the main components requiring attention during maintenance consist of the gauges, horn, safety warning devices, the lights and the overhead guard. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above parts have been checked carefully, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each and every battery cell should be inspected in order to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The hydraulic filter, the transmission filter and the fuel filters must be replaced regularly. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Inspect the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. After that, inspect each and every other component of the machinery like the wheels. If any type of concern or fault is detected, be certain to deal with it immediately in order to make certain the machine is working at its safest and optimum levels.